Connecting The Electrical Power To Magicspeed - Dometic MS880 Instructions De Montage Et De Service

Connecting the electrical power to MagicSpeed

8 Connecting the electrical power to
MagicSpeed
8.1 Laying and connecting the cable set
Please note the following:
• To prevent damage to the cables when laying them, ensure that they are far
enough away from hot or moving vehicle components (exhaust pipes, drive
shafts, light systems, fans, heater etc.).
• Wrap insulating tape around every connection on the cable (even inside the
vehicle).
• When laying the cables, make sure:
– they are not kinked or twisted
– they do not rub on edges
– they are not laid in sharp-edged ducts without protection (fig. 3, page 4).
• Protect every hole you drill against water penetration, e.g. by using a cable with
a sealant and by spraying the cable and the the cable sleeve with sealant.
You will find a summary of the wiring in fig. 7, page 6.
No. Component
1 Electronic module
2 Control element
3 Ignition coil
4 Engine speed signal
5 Brake light switch
6 Original clutch switch
7 Clutch switch
8 Ignition
9 Travel speed signal
10 Vehicle-specific cable set (not included)
18
MS880
EN