Technical Description; Display And Control Elements; Assembling And Connecting Dsp-Em - Dometic DSP-EM Instructions De Montage Et De Service

Technical description

6 Technical description
6.1 Function
A connected inverter can be switched on and off and be configured.
A connected MCA battery charger can be switched to sleep mode.
DSP-EM can communicate with a battery sensor of the MCA-HS1 Hella sensor type. With an IBS
multiplexer, up to four battery sensors can be connected.
6.2

Display and control elements

Item in
fig. 2,
Description
page 3
1 Selector button
2
3
4 Display
7

Assembling and connecting DSP-EM

When selecting the installation location, note the following:
• The device must be installed in a location that is protected from moisture.
• Do not install the device in a dusty environment.
• The device must be installed on a level and sufficiently sturdy surface.
• Note the length of the connection cable.
• Install the device in a well-protected location to ensure no objects can touch the connection
cable or cause it to tear.
➤ Prepare the cut-out in the wall with the template included in the scope of delivery.
➤ Mount the display as shown (fig. 3, page 4).
➤ Connect the display as follows(fig. 4, page 5).
10
Explanation
Turn: Navigate through menus or change values
Press: Select menu items or values
For connected inverter:
Deactivates the inverter function and thus the power supply
of the battery to the 230 V consumer units. The battery is not
discharged via the inverter.
For connected MCA charger:
Switches the night mode of the connected device on or off.
The charging current of the connected device is limited and
the fan switches off.
Displays values and current statuses of the connected
devices.
DSP-EM
EN