HIKOKI P 20SA2 Mode D'emploi page 9

h) Keep handles and grasping surfaces dry, clean
and free from oil and grease.
Slippery handles and grasping surfaces do not
allow for safe handling and control of the tool in
unexpected situations.
5) Service
a) Have your power tool serviced by a qualified
repair person using only identical replacement
parts.
This will ensure that the safety of the power tool is
maintained.
PRECAUTION
Keep children and infirm persons away.
When not in use, tools should be stored out of reach
of children and infirm persons.
SPECIFICATIONS
Voltage (by areas) *
Power Input
Cutting Width
Max. Cutting Depth
Weight **
No-Load Speed
* Be sure to check the nameplate on product as it is subject to change by areas.
** According to EPTA-Procedure 01/2014
STANDARD ACCESSORIES
In addition to the main unit (1 unit), the package contains
the accessories listed on page 35.
Standard accessories are subject to change without notice.
APPLICATIONS
○ Planing various wooden planks and panels.
(See Fig. 1-4)
PRIOR TO OPERATION
1. Power source
Ensure that the power source to be utilized conforms
to the power requirements specified on the product
nameplate.
2. Power switch
Ensure that the power switch is in the OFF position. If
the plug is connected to a receptacle while the power
switch is in the ON position, the power tool will start
operating immediately, which could cause a serious
accident.
PLANER SAFETY WARNINGS
1. Wait for the cutter to stop before settling the tool
down.
An exposed rotating cutter may engage the surface
leading to possible loss of control and serious injury.
2. Hold the power tool by insulated gripping surfaces,
because the cutter may contact its own cord. Cutting
a "live" wire may make exposed metal parts of the
power tool "live" and could give the operator an electric
shock.
3. Use clamps or another practical way to secure and
support the workpiece to a stable platform. Holding
the workpiece by your hand or against the body leaves
it unstable and may lead to loss of control.
4. Do not use the Planer with the blades facing upward (as
stationary type planer).
5. Use dust collection adapter if need to reduce dust
related hazards.
(1) Unscrew the Chip guide (Item no. 17 show in
assembly drawing) on housing.
(2) Mount dust collection adapter on housing with
screws instead of the Chip guide.
Dust collection adapter (Code no. 317279)
(3) Connect the dust extraction and collection facilities
with the tube of dust collection adapter firmly.
(110V, 115V, 120V, 127V, 220V, 230V, 240V)
720 W*
82 mm
3 mm
3.4 kg
14000 / min
3. Extension cord
When the work area is removed from the power source,
use an extension cord of sufficient thickness and rated
capacity. The extension cord should be kept as short as
practicable.
4. Prepare a stable wooden workbench suitable for
planing operation. As a poorly balanced workbench
creates a hazard, ensure it is securely positioned on
firm, level ground.
PLANING PROCEDURES
1. Adjusting the cutter depth:
(1) Turn the knob in the direction indicated by the arrow in
Fig. 5 (clockwise), until the triangular mark is aligned
with the desired cutting depth on the scale. The scale
unit is graduated in millimeters.
(2) The cutting depth can be adjusted within a range of
0-3 mm.
2. Surface cutting:
Rough cutting should be accomplished at large cutting
depths and at a suitable speed so that shavings
are smoothly ejected from the machine. To ensure
a smoothly finished surface, finish cutting should
be accomplished at small cutting depths and at low
feeding speed.
English
9