Vertic RCBC Notice D'utilisation page 10

manufacturing defect. The following are excluded from the warranty: normal wear and tear, oxidation, modifications or repairs, improper
storage, improper maintenance, damage due to accidents, negligence, use for which this product is not intended.
MAINTENANCE AND SERVICE
Any modification or addition to the equipment without the prior written consent of the manufacturer is prohibited.
Any repairs to system components must be made in accordance with VERTIC procedures. If in doubt about the condition of the product, replace
it with an original VERTIC part.
Soiled product should be washed and rinsed with clean water, then dried. It must not be brought into contact with corrosive or aggressive
materials, nor stored at extreme temperatures. All chemicals, solvents can alter the resistance of the system components. If the product is
likely to be in contact with these products, please tell us the exact name of the chemical components and we will reply to you after an
appropriate study.
It is mandatory to check the condition of the belay systems at least every 12 months by an authorized and competent person in strict
compliance with the VERTIC operating procedures. These periodic and regular examinations are necessary because user safety is linked to
maintaining the efficiency and resistance of the equipment. The control and the results must be recorded in writing in a maintenance booklet
through the identification and verification sheet provided by VERTIC.
ALPIC can also carry out all of these maintenance and verification operations.
ALPIC - Parc technologique - 691, Chemin des Fontaines – Cidex 8F - 38190 BERNIN
Téléphone : 04 76 16 30 30 – Fax : 04 76 13 12 16 - Email : alpic@alpic.fr http://www.alpic.fr
Page 10 / 22