Lincoln Electric POWER MIG 180C Manuel D'utilisation page 10

Load Wire Spool
1. Locate the blue labeled 102mm diameter spool of
0.9mm NR-211MP flux-cored wire and place onto
wire spool spindle. Orient the spool so that the wire
feeds off the top of the spool.
2. Secure spool in place by tightening the wing nut
against the against the spacer that holds the wire
spool on the spindle.
3. Open the top drive roll pressure arm by rotating the
tension adjustor arm down and pivoting the drive roll
pressure arm up.
4. Remove the outer wire guide.
5. Slide gun out of drive slightly.
6. Remove the lower drive roll and inner wire guide.
7. Install the 0.6mm-0.9mm inner wire guide.
8. Install the 0.8mm/1.1mm knurled lower drive roll.
9. Carefully unwind and straighten the first six inches
of welding wire from the spool. Do not let the end of
the wire go to prevent the wire from unspooling.
10. Feed the wire through the wire drive inlet along the
inner wire guide groove and into the wire drive outlet
on the gun side.
11. Close the top drive roll pressure arm and secure by
pivoting the tension adjustor back to the up position.
12. Re-install the outer wire guide.
13. Remove the nozzle from the gun and contact tip and
straighten the gun out flat.
14. Turn the machine power to on and depress the gun
trigger to feed the wire through the gun liner until the
wire comes out of the threaded end of the gun
several inches.
15. When trigger is released spool of wire should not
unwind. Adjust wire spool brake accordingly.
16. Install the 0.9mm contact tip.
17. Install the black flux cored welding nozzle to the
gun.
18. Trim the wire stickout to 9.5mm from the contact tip
19. Close the case side door. The machine is now
ready to weld.
20. Read "Learn to Weld" (LTW1) that is included with
the machine or watch the "How to Weld" DVD
included with the machine.
A-5
.