Faults - What To Do - Blaupunkt 5CR2 Série Notice D'utilisation

Masquer les pouces Voir aussi pour 5CR2 Série:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3
Faults – what to do?
B efore you call customer service, use this table to check whether you can rectify the
F a u l t s – w h a t t o d o ?
fault yourself.
Temperature differs greatly from the set value.
Displays do not illuminate.
The mains plug has not been inserted properly.
The fuse has tripped.
The power has failed.
Display indicates "E...".
Electronics have detected a fault.
Appliance is not cooling, display and lighting are lit.
Showroom mode switched on.
Automatic super function does not switch on.
--------
Switch off appliance for 5 minutes.
~ "Switching off and disconnecting the appliance"
on page 32
If the temperature is too warm, check temperature
again after a couple of hours.
If the temperature is too cold, check temperature
again on the following day.
Connect the mains plug.
Check the fuses.
Check whether the power is on.
Call the after-sales service.
~ "Customer service" on page 42
Start the appliance self-test.
~ "Appliance self-test" on page 42
When the programme has ended, the appliance
switches over to normal operation.
The appliance decides independently whether the
automatic super function is required and switches it
on or off automatically.
Faults – what to do? en
41

Publicité

Table des Matières
loading

Table des Matières