Eliminating Minor Faults Yourself - Blaupunkt 5CN2 Série Mode D'emploi

en

Eliminating minor faults yourself

Before you call customer service:
Please check whether you can eliminate the fault yourself based on the following
information.
Customer service will charge you for advice – even if the appliance is still under
guarantee!
Fault
The light does not work.
Floor of the refrigerator
compartment is wet.
The temperature in
the refrigerator
compartment is too cold.
The refrigerating unit
is switching on more
frequently and for longer.
Appliance has no
refrigeration capacity.
28
Possible cause
The bulb is defective.
Light switch is jammed.
The condensation channels
or drainage hole are blocked.
Temperature controller has
been set too high.
Appliance opened
frequently.
The ventilation openings
have been covered.
The temperature controller is
in position "0".
Power failure.
■
The fuse has been
■
switched off.
The mains plug has not
■
been inserted properly.
Remedial action
Replace bulb. Fig. +/B
1. Switch the appliance off.
2. Pull out mains plug or switch off fuse.
3. Slide cover forwards and remove.
4. Change the bulb.
(Replacement bulb: 220-240 V a.c., E14
bulb holder, see defective bulb for
wattage.)
Check whether the light switch can move.
Fig. +/A
Clean the condensation channels
and the drainage hole. See chapter Cleaning
the appliance. Fig. )
Set temperature controller lower.
Do not open the appliance unnecessarily.
Remove obstacles.
Turn the temperature controller from position
"0". Fig. "/A
Check whether the power is on, check
the fuses.