Danfoss VLT Micro Drive FC 51 Guide Rapide page 20

Quick Guide
1 1
Mode 1
1. Enter the main menu.
2. Go to parameter group 1-** Load and Motor.
3. Press [OK].
4. Set motor parameters using nameplate data for
parameter group 1-2* Motor Data.
5. Go to parameter 1-29 Automatic Motor Tuning
(AMT).
6. Press [OK].
7. Select [2] Enable AMT.
8. Press [OK].
9. The test runs automatically and indicates when it
is complete.
16
®
VLT Micro Drive FC 51
Mode 2
1.
2.
3.
4.
5.
6.
7.
8.
9.
NOTICE
In mode 2, the rotor rotates during the AMT progress.
Do not add any load on motor in this AMT progress.
Danfoss A/S © 10/2017 All rights reserved.
Enter the main menu.
Go to parameter group 1-** Load and Motor.
Press [OK].
Set motor parameters using nameplate data for
parameter group 1-2* Motor Data.
Go to parameter 1-29 Automatic Motor Tuning
(AMT).
Press [OK].
Select [3] Complete AMT with Rotating motor.
Press [OK].
The test runs automatically and indicates when it
is complete.
MG02BC4P