Philips Lumea SC2005 Mode D'emploi page 19

English
18
Technical specifications
Rated volta'e
Rated 'requency
Rated input
Protection a'ainst electric shock
Protections ratin'
Operatin' conditions
Lithium-ion battery
Troubleshooting
Problem
The device suddenly
switches o''.
The device/adapter
becomes warm durin'
char'in'
I cannot use the device
'rom the mains.
The 'ready to 'lash li'ht'
doesn't li'ht up when I
place the attachment on
my skin, but the coolin' 'an
works.
The 'ready to 'lash li'ht'
li'hts up 'reen but the
device does not produce a
'lash when I press the 'lash
button.
The device produces a
stran'e smell.
This chapter summarizes the most common problems you could encounter
with the device. I' you are unable to solve the problem with the in'ormation
below, visit www.philips.com/support 'or a list o' 'requently asked questions
or contact the Consumer Care Center in your country.
Possible cause
The rechar'eable batteries
are empty.
This is normal.
Due to sa'ety reasons it is not
possible to use the device
'rom the mains.
The overheat protection has
been activated.
The device needs to be reset. To reset the device, switch it o'' and
The attachment or the 'ilter
'lass is dirty.
You have not removed the
hairs on the area to be
treated properly. These hairs
may 'et burned and can
cause the smell.
100V-240V
50Hz-60Hz
7,5W
Class II
IP 30 (EN 60529)
Temperature:+15 ºC to 35º C
Relative humidity: 5% to 95%
2 x 3.7 Volt 1500 mAh
Solution
Char'e the device. See Chapter
Char'in'.
No action required.
Philips Lumea can only be used without
cord.
When the overheat protection has been
activated, the 'an still works. Do not
switch o'' the device, but let it cool down
'or approx.15 minutes be'ore you
continue to use it.
switch it on a'ain.
Clean the attachment care'ully.
Pretreat your skin be'ore you use Lumea.