Additional Information; Updating The Software; Limited Functions Available; Equipment Repairs - Cristec YPO-DISPLAY-R Manuel Utilisateur

4
3
* Not available on models YPO 12V-16A, 12V-25A and 24V-12A
** The charge stops if this alarm occurs. Available for all models except YPO 12V-16A, 12V-25A and
24V-12A
6

ADDITIONAL INFORMATION

6.1

UPDATING THE SOFTWARE

In case a newer firmware is available for the display monitor, it can be easily updated. Therefore, the new firmware
file has to be put on a Micro SD-card (Please use a micro SD-card with max. 4 GB). Then, the SD-card shall be inserted
into the holder on the top side of the display monitor and the unit has to be restarted from DC power. The updating
process will start automatically. After that, the SD-card shall be removed again.
6.2

LIMITED FUNCTIONS AVAILABLE

Depending on the model of charger and revision number, some functions like individual battery setting via the display
may not be available.
6.3 E
QUIPMENT REPAIRS
Disconnect the battery charger from the AC power network and disconnect the batteries before undertaking any
repairs.
In case of fuses blowing, respect the calibre and type of fuse recommended in this manual.
Please contact CRISTEC or their distributor for any other repairs.
Any repair without CRISTEC prior agreement entails an exclusion of warranty.
2
1 : Auto Start : if AC is available and charge is
OFF, this function automatically starts the
charge if a battery low alarm occurs *
2 : Home (return to main page)
3 : AC High : overvoltage alarm can be set
1
down to 265V. **
4 : AC Low : overvoltage alarm can be set up
to 85V. **
28