Operation Setup Menu; Charge On/Off (Not Available On Models Ypo 12V-16A, 12V-25A And 24V-12A) - Cristec YPO-DISPLAY-R Manuel Utilisateur

4.3.3 ON/OFF charger output
Charger output can be switched ON and OFF by pressing ON/OFF charger output [3] onto main page. *
In OFF mode, output current is 0A and therefore all battery voltages can be read.
AC Network voltage and frequency are available by pressing [4]. *
Press [3] to switch on the charger's output. *
5
4
* Not available on models YPO 12V-16A, 12V-25A and 24V-12A
4.4
OPERATION SETUP
Setup  Operation
By pressing the parameter access button [2] onto main page and next the OPERATION button, you can control
all the main functions of the charger.
5
4
* Not available on models YPO 12V-16A, 12V-25A and 24V-12A
3
( )
MENU
3
1 : Battery voltages
2 : Access to parameters
1
3 : ON/OFF charger output *
4 : AC network status
5 : Battery pack temperature (if probe
connected)
2
1 : Boost ON/OFF (see 4.4.1)
2 : Charge ON/OFF *
1
3 : Home (return to main page)
4 : Night Mode (see 4.4.5)
5 : Current limit (see 4.4.4)
2
23