Interface Board; See Appendix - Cristec YPO-DISPLAY-R Manuel Utilisateur

3.1 I
NTERFACE BOARD
Make sure the battery charger is disconnected from AC mains and DC outlet is disconnected before
you plug the interface board.
After removal of the metal front cover, the red 16 pole connector of the ribbon cable has to be plugged into the
matching red connector placed on the mainboard of the YPO battery charger.
The interface board has to be hooked to the three plastic brackets on the housing.
3.2 W –
IRING

SEE APPENDIX

The Remote Display shall be connected to the interface board
via a 3 pole cable. The cable can be shortened or you can use
a cable up to 15m. The 3 pole cable provides the power
supply of the monitor as well as LIN-Bus communication.
When assembling the connectors to the wires, please use the
pigtails and the 3 pole cable which is part of the delivery.
PIN 1, 2 and 3 have to be connected in the same orientation
on both connectors. Both LIN Terminals are connected in
parallel, so only one has to be used. The second one is
dedicated for further applications.
1
20