Télécharger Imprimer la page

Siemens DE04101 Notice De Montage Et D'utilisation page 24

Masquer les pouces Voir aussi pour DE04101:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 28
After installation
DE05101, DE06101, DE06111, DE08101
and DE08111 (fixed electrical connection)
Switch on the fuses.
DE04101 and DE10104
Insert the plug into the mains socket.
First start-up
Initial rinsing
Open the warm water tap and allow water to
flow for at least 1 minute (flow-rate at least
2 litres per minute). Only then (for safety rea-
sons) will the appliance begin to heat.
Info: The appliance will not heat if the dispensed
water flow is interrupted prematurely. Open the
warm water tap again and allow water to flow
for at least 1 minute.
Tip: Should the appliance not start because of a
reduced flow-rate, remove the perlator, aerator or
similar before starting and repeating the process.
Important
H1
24
en
H2
Important: If the continuous-flow heater does not
have sufficient water flow due to low water line
pressure in your domestic plumbing system:
Switch off the circuit-breakers/fuses or remove
the mains plug.
Remove the flow-rate limiter (
Controlling temperature
The supply temperature (probably lower in winter)
and pressure fluctuations can influence the tem-
perature of the water leaving the tap (refer to figure
on page 22).
Turn the valve slowly in the closed direction for
higher temperatures (F1).
Add cold water for lower temperatures (
Hand over the installation and operating instruc-
tions to the user and explain how the appliance
operates.
H3
H1 – H4).
F2).
H4

Publicité

loading

Ce manuel est également adapté pour:

De10104De05101De06101De06111De08101De08111