Hama RCR 110 Mode D'emploi page 6

Display (6)
/
Display ashing
Display steady
(not ashing)
Display steady
(not ashing)
Not display
• Press and hold the °C/°F/WAVE button (5) for approx. 3
seconds to start a manual search for the DCF radio signal.
Note – Manual search
• The manual search is automatically aborted after 3-5 minutes.
• Using the wave °C/°F/WAVE (5) frequently will drain the
battery. We recommend only using this function to seek out
an optimal location for the device.
Note – Summer time
The clock automatically switches to summer time.
on the display as long as summer time is activated.
5.2. Manually setting the date/time
• Press and hold the MODE button (4) for approx. 3 seconds until
the hours display begins to ash.
• Set the following information in the order listed:
• Year
• Month
• Day
• Hours
• Minutes
• To select the individual values, press the ▲ button (3) or the 
button (2) and con rm each selection by pressing the MODE
button (4).
• Press the MODE button (4) immediately to adopt the set value
displayed and skip ahead.
• If you do not make an entry for 30 seconds, you automatically
exit the setup mode.
4
Searching for the DCF signal
Active
Successful – signal is being received
Success – weak signal reception
Inactive – no signal reception
appears
Weekday
• To change the language in which the weekday is displayed,
press the  button (2) for 3 seconds. The current language
will be displayed.
• Hold down the  button (2) to change to the other languages.
Note – Day of the week
You can choose German (GE), English (EN), Italian (IT), Spanish
(SP) or French (FR) for the weekday display.
Setting the time zone
Note – Time zone
• The DCF signal can be received over long distances, but
always transmits the current Central European Time in
Germany. Make sure you account for the time difference in
countries with another time zone.
• If you are in Moscow, the time is 3 hours later than in
Germany. This means that you should set +3 for the time
zone. The clock then automatically sets the time to 3 hours
after the DCF signal received or relative to the manually
set time.
• Press and hold the ▲ button (3) for approx. 3 seconds until the
time zone symbol F is displayed.
• Press and hold the MODE button (4) for approx. 3 seconds to
set the required time zone difference.
• To select the individual values, press the ▲ button (3) or the 
button (2) and con rm each selection by pressing the MODE
button (4).
• Press and hold the ▲ button (3) for 3 seconds to switch the
display between local and time zone-shifted time.
Selecting 12 or 24-hour format
• Press the ▲ button (3) to switch between the 12 and 24-hour
formats.
Selecting weekday/calendar week display
• Press the  button (2) to switch between displaying the
weekday and the calendar week (WEEK).
5.3. Temperature display
• Press the °C/°F/WAVE button (5) to choose between °C and °F
for the temperature display.
5.4. Alarm
Note – Alarm
The alarm time always depends on the time displayed, that is,
the local or time zone-shifted time ( ).
F