Bosch DNM 60 L PROFESSIONAL Instructions D'emploi page 22

OBJ_BUCH-17-004.book Page 22 Monday, June 12, 2006 11:10 AM
Alignment Aids
The alignment aids a on the display
indicate in which direction the measur-
ing tool is to be turned in order to reach
the horizontal or vertical plane.
For 0.1° to 44.9° the arrows point to
the horizontal, for 45.1° to 89.9° to the
vertical plane. For 0° and 90° the
arrows go out.
Rotation of the Reading
Depending on the position of the
measuring tool, the measured value
and the unit of measure are indicated in
the display rotated by 180°. Thus, the
indication can also be read for over-
head work.
Holding/Copying a Measured
Value
Two functions can be controlled with
the "HOLD/COPY" 11 button:
• Holding ("Hold") of a measured
value, even when the measuring
tool is moved afterwards,
• Copying ("Copy") of a measured
value.
"Hold" function:
• Switch the acoustic signal off (see
"Acoustic Signal").
• Press the "HOLD/COPY" 11 but-
ton. The current measured value on
the display is held, the unit of meas-
ure e and the alignment aids a flash.
• Press the "HOLD/COPY" 11 but-
ton again to start a new measure-
ment.
"Copy" function:
• Switch the acoustic signal on (see
"Acoustic Signal").
• Press the "HOLD/COPY" 11 but-
ton. The current measured value is
stored. A short signal sounds, the
unit of measure e and acoustic sig-
nal c flash.
• Position the measuring tool at the
target location where the measured
value is to be copied. The alignment
aids a indicate the direction in which
the measuring tool has to be moved
in order to reach the angle to be
copied. An acoustic signal sounds
upon reaching the memorised angle
and the alignment aids a go out.
• Press the "HOLD/COPY" 11 but-
ton again to start a new measure-
ment.
22 | English
1 609 929 K06 • 12.6.06