Connecting The Speakers - Teac LS-101HR Mode D'emploi

Speaker cables
o Use the included speaker cables or commercial-
ly-available cables designed for speakers.
o We recommend using the shortest speaker
cables possible.
o We recommend using left and right speaker
cables of the same length.
CAUTION
Before connecting
Always turn the amplifier's power OFF before
connecting speakers.
After connecting
Turn the volume down completely before turning
the amplifier's power ON to prevent sudden loud
noises.
Confirm that the speaker terminals have been
connected correctly and that cables are not
contacting other terminals.
Connecting the cables
Bare/sleeved wire
Insert the core wire through the hole in the terminal
completely and tighten the cap firmly.

Connecting the speakers (1)

Spade lugs
Place the spade around the terminal and tighten the
cap firmly.
o When using spade lugs to connect the speakers,
they should have an inside diameter of at least 8
mm (3/8").
Banana plugs
Tighten the cap
After connecting the banana plug to the speaker
cable, insert the plug into the terminal.
o Carefully read the instructions for the banana
plugs that you are using.
Notice about the European model
In accordance with European safety regulations,
connecting banana plugs to speaker terminals is not
allowed on European models. The holes into which
banana plugs could be inserted have been covered
with black caps. Connect speakers using bare wires
or spade lugs. If a black cap should become separat-
ed from its terminal, return it to its original position.
5