Publicité
Les langues disponibles
Les langues disponibles
Fax +32 030 9904733
extension cords is not recommended; if their use is indispensable, they must conform to existing
safety standards and their current capacity (amperes) must not be less that the maximum of the
appliance.
• The power socket must be easy to reach so the plug can be removed quickly in case of
emergency.
• Do not place the fan on a shelf and/or near sinks or other container of liquids (minimum distance
of 2 meters) to avoid the risk of it falling in.
• Keep the fan far away from fabrics (curtains, etc.) or unstable materials that could obstruct the air
intake grille; make sure that the front is free of unstable materials (dust, etc.).
• Make sure that the electric cord is not touching rough, hot or moving surfaces and not twisted or
wrapped around the appliance.
• Stand the appliance on a horizontal, flat surface or table; do not stand on a inclined plane (the
appliance could upset).
• Do not place the appliance near an open flame, cooking or other heating appliance.
• Do not use the appliance with a timer or a programmer or with a system that can switch on the
appliance automatically, to avoid risk of fire, since a fire risk exists if the heater is covered or
positioned incorrectly.
• In the event of a breakdown or poor operation, turn the fan heater off and ask for professionally
qualified help.
ASSEMBLY
Attention: the fan can be used only when completely and correctly assembled, that is complete with
its base and protection grid. If in doubt, have the appliance checked or assembled by a qualified
professional person. For assembly, refer to fig. 1.
1) Engage the base on the bottom part of the column, making sure they are correctly positioned one
against the other. Fasten the parts using the screw provided (11) and lock them in a normal way.
2) Fasten the rear grid (6) to the motor casing, positioning the corresponding pins and holes, and
lock using the appropriate ring nut (5).
3) Insert the fan (3) on the motor shaft and lock with the appropriate ring nut (2) turning it tightly
anti-clockwise.
4) Couple the front grid (1) with the rear grid (6) and lock with the plastic ring (4) and ensure the
fastening with the appropriate locking screw, (the screw must be in the lower part). Having done
this, check that the protection grid is firmly coupled and fastened to the motor.
USE
Before each use, make sure the electric cord is in good condition.
Insert the plug of the fan in the power supply.
Ventilation: select the desired speed with the selector (8).
1– Minimum speed 2–Medium speed 3–Maximum speed
To turn off, turn the switch to position 0 and then remove the plug from the socket.
Horizontal oscillation (right-left): this is selected with the button (7) located on the motor body.
To stop the motion and keep the ventilator still, press the button.
Vertical inclination (high-low): it is regulated by gripping the motor body and orienting it in the
direction desired; you will hear "clicks" that indicate the fan's various positions.
When not in use for long periods, the plug must always be removed from the socket.
CLEANING AND MAINTENANCE
Attention: before normal cleaning, remove the plug from the socket.
• Ensure that the fan is switched off from the supply mains before removing the guard.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar (Italy).
The pages must be reproduced and folded in order to obtain
a booklet A5 (+/- 148.5 mm width x 210 mm height). When
folding, make sure you keep the good numbering when you
turn the pages of the I/B. Don't change the page numbering.
Keep the language integrity.
7
16
/
Assembly page 7/16
Publicité
