Erasing Recordings - Teac AD-850 Mode D'emploi

6
Press the RECORD TAPE button again to start recording.
When recording from an external source, you must also start
playback of the source.
If the recording source is a CD or USB flash drive, that source will
automatically start playing back.
o Pressing either the TAPE Pause (9) or TAPE Play (t) button
will start recording.
The red indicator above the RECORD TAPE button and the
icon on the display stop blinking.
< To pause recording, press the TAPE Pause (J) button. Press the
button again to resume recording.
Pressing the RECORD TAPE or TAPE Play (t) button will also
resume recording. You can also resume recording by pressing
the source playback button if the recording source is a CD or USB
flash drive.
Recording from a CD or a USB flash drive
When source playback stops, recording also automatically stops.
To stop recording, press the TAPE Stop (H) button. Doing this
also stops playback of the recording source.
Recording from an external source
When source playback stops, recording does not automatically
stop. Press the TAPE Stop (H) button to stop recording.

Erasing recordings

When you make a recording, the tape is overwritten (the previous
recording is erased). You can erase a tape recording by setting the
recording level to MIN and recording silence.
1
Press the TAPE RECORD button to start recording
standby.
2
Set the REC LEVEL control to the minimum MIN position.
3
Press the TAPE RECORD button to start erasing (by
recording silence).
33