Identifying The Parts (Main Unit) - Teac AD-850 Mode D'emploi

32 31
1
Display
This shows the total number of tracks/files, playback time and
other information (page 14).
2
Remote sensor
When operating the remote control, point it towards here.
3
OPEN/CLOSE (L) button
Press this button to open and close the disc tray.
4
COUNTER RESET button
Press this button to reset the tape counter to "0000".
5
REC LEVEL knob
Turn this knob to adjust the recording level.
6
Skip (.//)/Search (m/,) buttons
Press these buttons to skip through tracks/files.
Hold down these buttons to search for part of a track/file.
7
REPEAT button
Use this button to set the repeat function (page 20).
8
SOURCE button
Use this button to select the source (page 17).
9
Stop (H) button
Press this button to stop cassette tape playback.
Press this button to stop recording to a tape.
12

Identifying the parts (main unit)

1
30 29 28 27
2 3 4 5 6
26 25 24 23 22 21
10
RECORD USB button
Use to record to an external USB flash drive. Press it once to
enable recording standby, and press it again to start recording
(page 28).
Press it during recording to divide the file at that point (page
30).
11
RECORD TAPE button
Use to record to a tape. Press it once to enable recording standby,
and press it again to start recording (page 31).
12
Fast-forward/Rewind (m/,) buttons
Press these buttons to fast-forward/rewind the cassette tape.
13
Pause (J) button
Press this button to pause cassette tape playback or recording.
Press this button again to resume playback or recording.
14
Cassette tape compartment
15
MIC connector and mic LEVEL knob
When using a mic to record, insert the mic cable plug into this
connector and turn the knob to a suitable level (page 34).
This unit does not support stereo mics.
Use a mono dynamic mic.
Set the MIC LEVEL knob to MIN when not using a mic.
8 10 11
7 9 12 13
20 19 18 17