Memory Upgrade Module; Installing Memory Upgrade Modules - Fujitsu LIFEBOOK S751 Mode D'emploi

Memory Upgrade Module

Your Fujitsu LIFEBOOK notebook comes with a minimum of 2 GB of high speed Double Data Rate
Synchronous Dynamic RAM (DDR3-1333 SDRAM) factory installed. To increase your notebook's memory
capacity, you may install an additional memory upgrade module. The memory upgrade must be a dual-in-
line (DIMM) SDRAM module. To ensure 100% compatibility, purchase the SDRAM module only from
the Fujitsu web store at www.shopfujitsu.com

Installing Memory Upgrade Modules

1
Turn off power to your notebook, remove any power adapter (AC or auto/airline). Remove the battery.
2
Make sure that all the connector covers are closed.
3
Turn the notebook bottom side up, remove the screw from the memory upgrade module compartment, and
remove the cover.
4
Remove the new memory upgrade module from the static guarded sleeve.
5
Align the memory upgrade module with the part side up. Align the connector edge of the memory upgrade
module with the connector slot in the compartment.
•
D
O NOT REMOVE ANY SCREWS FROM THE MEMORY UPGRADE MODULE COMPARTMENT EXCEPT THE
ONES SPECIFICALLY SHOWN IN THE DIRECTIONS FOR INSTALLING AND REMOVING THE MEMORY
.
UPGRADE MODULE
•
T
HE MEMORY UPGRADE MODULE CAN BE SEVERELY DAMAGED BY ELECTROSTATIC DISCHARGE
T
O MINIMIZE RISK TO THE MODULE
- B
EFORE HANDLING A MEMORY MODULE
STATIC ELECTRICITY BUILT UP IN YOUR BODY
- W
HEN INSTALLING OR REMOVING A MEMORY MODULE
ANY CONTACTS OR CHIPS
;
COMPONENTS THE OIL FROM YOUR FINGERS COULD CAUSE A SHORT TO THE COMPONENTS
- B
E SURE TO POWER DOWN YOUR SYSTEM BEFORE ADDING OR REMOVING MEMORY MODULES
E
VEN IF THE SYSTEM IS IN HIBERNATE OR SLEEP STATES
COULD BE DAMAGED IF POWER IS STILL AVAILABLE TO THE SYSTEM
(Figure 22)
,
OBSERVE THE FOLLOWING PRECAUTIONS
,
TOUCH A GROUNDED METAL OBJECT TO DISCHARGE
.
. B
E CAREFUL NOT TO TOUCH ANY INTERNAL COMPUTER TERMINALS OR
(Figure 23)
72
:
,
HOLD IT BY THE EDGE SO AS NOT TO TOUCH
,
DATA COULD BE LOST OR THE MEMORY
.
(ESD).
.
.