Memory Upgrade Module; Installing Memory Upgrade Modules - Fujitsu LIFEBOOK AH752 Mode D'emploi

Memory Upgrade Module

Your Fujitsu LIFEBOOK notebook comes with a minimum of 4GB of high speed Double Data Rate
Synchronous Dynamic RAM (DDR3-1333 MHz SDRAM factory installed. To increase your notebook's
memory capacity, you may install an additional memory upgrade module. The memory upgrade must be a
dual-in-line (DIMM) SDRAM module. To ensure 100% compatibility, purchase the SDRAM module only
from the Fujitsu web store at www.shopfujitsu.com

Installing Memory Upgrade Modules

1
Turn off power to your notebook, remove any power adapter (AC or auto/airline). Remove the battery.
2
Make sure that all the connector covers are closed.
3
Turn the notebook bottom side up, and remove the screw from the memory upgrade module compartment (see
Figure 25).
4
Remove the cover.
5
Remove the memory upgrade module from the static guarded sleeve.
•
D
O NOT REMOVE ANY SCREWS FROM THE MEMORY UPGRADE MODULE COMPARTMENT EXCEPT THE
ONES SPECIFICALLY SHOWN IN THE DIRECTIONS FOR INSTALLING AND REMOVING THE MEMORY
.
UPGRADE MODULE
•
T
HE MEMORY UPGRADE MODULE CAN BE SEVERELY DAMAGED BY ELECTROSTATIC DISCHARGE
T
O MINIMIZE RISK TO THE MODULE
•
B
EFORE HANDLING A MEMORY MODULE
STATIC ELECTRICITY BUILT UP IN YOUR BODY
•
W
HEN INSTALLING OR REMOVING A MEMORY MODULE
TOUCH ANY CONTACTS OR CHIPS
TERMINALS OR COMPONENTS
.
COMPONENTS
•
B
E SURE TO POWER DOWN YOUR SYSTEM BEFORE ADDING OR REMOVING MEMORY MODULES
E
VEN IF THE SYSTEM IS IN HIBERNATE OR STANDBY STATES
MEMORY COULD BE DAMAGED IF POWER IS STILL AVAILABLE TO THE SYSTEM
64 - Memory Upgrade Module
.
,
OBSERVE THE FOLLOWING PRECAUTIONS
,
TOUCH A GROUNDED METAL OBJECT TO DISCHARGE
.
,
HOLD IT BY THE EDGE SO AS NOT TO
. B
E CAREFUL NOT TO TOUCH ANY INTERNAL COMPUTER
;
THE OIL FROM YOUR FINGERS COULD CAUSE A SHORT TO THE
:
,
DATA COULD BE LOST OR THE
.
(ESD).
.