Refilling The Water Tank; Emptying The Ice Bucket; Draining The Ice Maker - Rotel U9903CH Mode D'emploi

 REFILLING THE WATER TANK
The ADD WATER indicator light will turn on and the ice maker will automatically stop when
the water tank is empty or the water pump within the tank cannot inject water through the
ice making mechanism.
o Press the ON/OFF button.
o Fill the water tank up to the maximum water level line.
o Allow the refrigerant in the compressor to settle for at least 3 minutes.
o Press the ON/OFF button again to restart the unit.
 EMPTYING THE ICE BUCKET
The ice maker will stop producing more ice when the ice basket is full. If this occurs, the ICE
FULL indicator will turn on.
o Empty the ice into a freezer or use as needed.
o Unused ice will melt back into the water tank and be recycled into fresh ice.
Note: Direct or indirect sunlight may cause the infrared sensor within the unit to malfunction.
If the unit does not stop producing ice even when the basket is full, move the unit to an area
away from sunlight.
 DRAINING THE ICE MAKER
o Position the drainage port on the bottom of the unit over a sink, or place a small
container or receptacle under the drainage port.
o Remove the plug and allow water to drain out completely.
Note: change the water in the water reservoir every 24 hours to ensure clean ice.
Gebrauchsanweisung ○ Mode d'emploi ○ Istruzioni per l'uso ○ Instruction for use
38