Starting Up The Appliance; Using Your Appliance; Cleaning & Maintenance - Rotel U9901CH Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

 STARTING UP THE APPLIANCE
o
During transport, do not tilt the appliance at an angle of over 45°.
o
Do not transport the appliance upside down.
o
Before first use of the ice maker after delivery or transport, please MAKE SURE that
the appliance has been standing in a horizontal position for a minimum of 2 hours.
o
The appliance is designed for domestic use only and should not be used for
commercial purposes.
 USING YOUR APPLIANCE
o
Open the lid (B) and lift out the ice cube collector (A). Fill the water tank up to the
maximum level mark. Caution, use drinking water only.
o
Choose the desired ice cube size, S (small), M (medium), or L (large) (5/6/7), using
the selection button (2). The last setting will remain until you reset it or unplug the
appliance from the mains. The default setting is medium-sized. CAUTION: If the
room temperature is lower than 15°C, choose small ice cube size (S) since the ice
may expand and stick together. If the room temperature is above 30°C, we
recommend the large setting (L).
o
To start operation, press the On button (1).
o
To end ice production, press the Stop button (3) and empty the water from the
water tank (C).
o
Due to the fast freezing process, ice cubes may look "cloudy". This is due to air
trapped in the water. It neither affects the quality nor the taste of the ice cubes.
o
If the water indicator (8) lights up, fill the water tank up to the maximum level mark.
Press the Stop button and then the Start button to restart the appliance.
o
If the Ice indicator lights up (4), the ice cube collector (A) is full and must be
emptied. After emptying the collector, press the Stop button and then the Start
button to restart the process.
 CLEANING/MAINTENANCE
o
Before cleaning the appliance, always unplug it from the mains.
o
Make sure to clean the interior of the appliance from time to time.
o
Remove all ice cubes. Use a water/vinegar solution to clean the interior and exterior
surfaces. Do NOT use any chemicals, acids, spirits or oil.
o
Change the water in the tank at least every 24 hours.
o
If you do not use the ice maker for a while, empty the superfluous water using the
water release screw (D).
Gebrauchsanweisung ○ Mode d'emploi ○ Istruzioni per l'uso ○ Instruction for use

Publicité

Table des Matières
loading

Table des Matières