Functional Description; Charging The Built-In Battery - Makita CL111D Manuel D'instruction

If electrolyte gets into your eyes,
4.
rinse them out with clear water and
seek medical attention right away. It
may result in loss of your eyesight.
Do not short the built-in battery:
5.
Do not touch the terminals with
1.
any conductive material.
Avoid storing built-in battery
2.
in a container with other metal
objects such as nails, coins, etc.
Do not expose built-in battery to
3.
water or rain.
A battery short can cause a
large current flow, overheat-
ing, possible burns and even a
breakdown.
Do not store the tool and built-in bat-
6.
tery in locations where the tempera-
ture may reach or exceed 50°C (122°F).
Do not incinerate the built-in battery
7.
even if it is severely damaged or is
completely worn out. The built-in
battery can explode in a fire.
Be careful not to drop or strike
8.
battery.
Follow your local regulations relat-
9.
ing to disposal of battery.
SAVE THESE
INSTRUCTIONS.
Tips for maintaining maximum
battery life
Charge the built-in battery before
1.
completely discharged.
Always stop tool operation and
charge the built-in battery when you
notice less tool power.
Never recharge a fully charged
2.
built-in battery.
Overcharging shortens the battery
service life.
Charge the built-in battery with
3.
room temperature at 10°C - 40°C
(50°F - 104°F). Let a hot built-in bat-
tery cool down before charging it.
Charge the battery cartridge once in
4.
every six months if you do not use it
for a long period of time.
FUNCTIONAL
DESCRIPTION

Charging the built-in battery

CAUTION:
Do not operate the cleaner during
charging. It may be damaged.
CAUTION:
Always disconnect the charging
plug from the cleaner after charging.
CAUTION:
Do not leave the charger in the
mains after disconnecting the appliance. Small
children may put the live plug in their mouth and
cause injury.
Use only the Makita charger DC1001 to charge this
cleaner. Use of the other type chargers may cause the
battery to burst, result in personal injury and damage.
Charge the cleaner when using it for the first time or
uncharged for a long time. Connect the charging plug to
the charging connector, then plug in the charger to the
power receptacle.
The battery power lamp lights up and start charging.
Charging takes approximately 3 hours. The light goes
out after the charging is complete. For more details,
refer to the instruction manual of battery charger.
1
► 1 . Battery power lamp
4 ENGLISH