Controls And Indicators - Candy GVC 71013NB Mode D'emploi

Water Tank
Indicator
Time Selection Delay Start
Button
Button
Control Panel and Indicator Lights
Programme Selector – Select the required programme.
Time Selection Button
Programme Selector. It can be used only with the selection of: Mix&Dry, Shirts and Time
Programmes.
Delay Start Button
Operation ).
Acrylic and Synthetic Button –
when pressed Acrylic Synthetics option is activated and the indicator
Anti- Crease Button
Start/Pause Button
Memo Button – Allows user to record the programme by pressing simultaneously the Anti-
Crease and the Acrylic Synthetic buttons for 3 seconds, after 2 minutes duration of the chosen
programme/option.
Filter Care indicator
Empty Water indicator
Program Display – Related indicator lights when a auto programme has been selected.
Refresh – The indicator lights up when the programme starts the cool down stage.
SELECTING THE PROGRAMME
EN 10

CONTROLS AND INDICATORS

Filter Care
Programme
Indicator
Display
Acrylic Synthetic
Button
– Allows the user to change duration of the programme selected by
– Allows the user to delay the start of the drying cycle (see details of
Press to select the type of fabrics to dry Acrylic and synthetics,
– Allows the user to select a post drying anti-crease cycle.
– Press to commence/ to pause the selected drying programme.
– Lights when the filter needs cleaning.
– Lights when the water container is full.
The Candy Sensor Dry machine gives many options for drying the
laundry to suit all circumstances. The table on the next page lists
the programmes and the function of each programme.
Note:
The sensor may not detect a small load of small articles. For small
loads and separate items or pre-dried fabrics with low moisture
content, use the timed programmes.
If the sensor does not detect the item the dryer will only operate for
10 minutes before going into cooldown.
If the load is too large or too wet to tumble dry the dryer will
automatically go into cooldown after approximately 3 hours.
In these cases we advise to use a time cycles between 30 and
75minutes depending on the load size and dryness required, and
select high or low heat depending upon the fabric type.
Start/Pause
Anti-Crease
Button
Button
Programme
Selector
lights up.