Controls And Indicators - Candy GO DV 38 Mode D'emploi

40005084Eng.qxd 04/07/2007

Controls and indicators

TIME REMAINING
DISPLAY
ACRYLICS/
SYNTHETICS
BUTTON
(Séchage Délicat)
Control panel and indicator lights
Programme Selector – Select the required programme
'Marche Arrêt' button and indicator – Press to switch on, the indicator will
light
'Départ' button – Press to commence the selected drying programme. Press for
5 seconds to cancel/reset the programme
'Séchage Délicat' button – Press to reduce the heat level for delicate items, the
indicator above the button will light up. To change the heat setting the
programme must be reset.
Low Heat – Indicator light ON
'Filtre' Indicator – Lights when the filter needs cleaning
'Départ Différé' Button – Allows the user to delay the start of the drying cycle
(see details of operation on page 14).
Time Remaining Display
START – When the dryer is switched On the START indicator will flash, when
the programme starts the START indicator will light up
60' – Indicator lights when there is less than 60 minutes left until completion
of the programme
15' – Indicator lights when there is less than 15 minutes left until completion
of the programme. At this stage of the drying cycle the machine enters the
Cool down phase
STOP – Indicator lights when the programme is finished.
6h – 6 hour start delay (light flashes when in operation)
9h – 9 hour start delay (light flashes when in operation)
11:01 Page 11
FILTER CARE
INDICATOR (Filtre)
START START DELAY
BUTTON BUTTON
(Départ) (Départ
Différé)
ON/OFF PROGRAMME
BUTTON SELECTOR
(Marche
Arrêt)
High Heat – Indicator light OFF
11