Hobie Cat Trax Manuel D'assemblage page 3

CAT TRAX
Listed below are the locations on the axle for the wheels and supports for your Hobie Model.
Simply find what Hobie you have and position the parts accordingly.
Note: The strap for the hull support should sit inside the measurement given.
Hobie Cat Teddy + Wave + Dragoon + 15 + Club Med
⇒ Wheels
⇒ Hull supports (measure in from each axle end)
Hobie Cat 14 + 16 +17 +18
⇒ Wheels
⇒ Hull supports (measure in from each axle end)
Hobie Cat FX1 + Pacific + Tiger + Fox
⇒ Wheels
⇒ Hull supports (measure in from each axle end)
Hull support
A
Wheel
Split pin
Stainless steel washer
Plastic washer
Plastic bearings
inboard position
A = 275mm
inboard position
A = 185mm
inboard position
A = 125mm
Axle
Support
straps
Bolts &
washers
Split pin
Stainless steel washer
Plastic washer
End plug
Rope