Sony CMT-MD1 Mode D'emploi page 19

1
Press TUNER/BAND (or TUNER
BAND on the remote) repeatedly
until the band you want appears.
Each time you press the button, the band
changes as follows:
FM ˜ AM
F M 8 . M H z 7 5
2
Press TUNING MODE on the
remote repeatedly until "PRESET"
appears.
F M 8 . M H z 7 5
3
Press TUNING + or – (or PRESET +
or – on the remote) to select the
desired station's preset number.
F M 8 . 7
Frequency or the station
name* or RDS station
name**
* If you label a preset station, it appears
in the display.
** European model only.
LEVEL SYNC -
DBFB
MANUAL
LEVEL SYNC -
DBFB
PRESET
LEVEL SYNC -
DBFB
PRESET
5 M H z 1
The
preset
number
To Do this
Press 1/u to turn off the
Turn off the
radio system.
Adjust the Press VOLUME +/– (or
VOL +/– on the remote).
volume
To listen to non-preset radio
stations
• Press TUNING MODE on the remote
repeatedly until "MANUAL" appears in
step 2, then press TUNING + or – to tune in
the desired station (Manual Tuning).
• Press TUNING MODE on the remote
repeatedly until "AUTO" appears in step 2,
then press TUNING + or –. The frequency
indication changes and scanning stops
when the system tunes in a station
(Automatic Tuning).
To cancel the Automatic Tuning
Press TUNING MODE on the remote.
Tips
• Pressing TUNER/BAND (or TUNER BAND on
the remote) when the power is off automatically
turns the power on and tunes in the last received
station (One Touch Play).
• You can switch from another source to the tuner
by pressing TUNER/BAND (or TUNER BAND on
the remote) (Automatic Source Selection).
• To improve broadcast reception, reorient the
supplied antennas or connect the optional external
antenna.
• When an FM program has static noise, press
STEREO/MONO on the remote until "MONO"
appears. There will be no stereo effect, but the
reception will improve. Press the button again to
restore the stereo effect.
19