Specifications; Assembly Procedures; Drive Shaft Tube; Engine - Hitachi CG 25EUSL Instructions De Sécurité Et Mode D'emploi

English

SPECIFICATIONS

Engine Size
(cu. in.)
Spark Plug
Fuel Tank Capacity
(fl . oz)
Engine Oil Capacity
(fl . oz)
Dry Weight (lbs)
Sound pressure
level
LpA (dB (A))
(EN27917)
Measured sound
power level LwA
(dB (A))
Guaranteed sound
power level LwA
(dB (A))
Vibration level
(m/s ) (ISO7916)
2
Front handle
Rear handle
NOTE
Equivalent noise
calculated as the time-weighted energy total
for noise/vibration levels under various working
conditions with the following time distribution: 1/2
Idle, 1/2 racing.
* All data is subject to change without notice.
6
Model CG25EUS (L)
1.53 (25 mℓ)
NGK CMR5H
or equivalent
16.7 (0.5ℓ)
2.7 (80 mℓ)
11.0 (5.0 kg)
81.8 78.6
101.8 98.6
104 101
4.8 4.5
3.2 4.6
level/vibration level

ASSEMBLY PROCEDURES

Drive shaft to engine (Fig. 1)
Loosen tube locking bolt (1) so that the bolt point will
not obstruct drive shaft tube to be inserted. When
inserting drive shaft tube, hold the tube locking bolt
outward preventing inside fi tting from obstructing as
well.
Insert the drive shaft into the clutch case of the
engine properly until the marked position (2) on the
drive shaft tube meets the clutch case.
NOTE
○ When it is hard to insert drive shaft up to the
marked position on the drive shaft tube, turn drive
shaft by the cutter mounting end clockwise or
counter-clockwise. Tighten tube locking bolt lining
up the hole in the shaft tube.
Then tighten clamp bolt securely (3).
Installation of handle (Fig. 2)
Attach the handle to the drive shaft tube with the
angle towards the engine.
Adjust the location to the most comfortable position
are
before operation.
NOTE
If your unit has handle location label on drive shaft
tube, follow indication.
1
3
2
Fig. 1
Fig. 2