Fig. 26 - Hitachi CG 25EUSL Instructions De Sécurité Et Mode D'emploi

clean it and check the electrode gap. Readjust if
necessary. The correct gap is .024˝ (0.6 mm). The
spark plug should be replaced after about 100
operation hours or earlier if the electrodes are badly
eroded.
NOTE
In some areas, local law requires using a resistor
spark plug to suppress ignition signals. If this
machine was originally equipped with resistor
spark plug, use same type of spark plug for
replacement.
Semi-auto cutting head
Nylon line replacement
(1) Remove the case (19) by fi rmly pushing inward
the locking tabs with your thumbs as shown in Fig.
26.
(2) After removing the case, take out the reel and
discard the remaining line.
(3) Fold the new nylon line unevenly in half as shown
in picture.
Hook the U-shaped end of the nylon line into the
groove (20) on the center partition of the reel.
Wind both halves of the line on the reel in the
same direction, keeping each half of the line on its
own side of the partition. (Fig. 27)
4˝ (10 cm)
(4) Push each line into the stopper holes (21), leaving
the loose ends approx. 4˝ (10 cm) in length.
(Fig. 28)
19

Fig. 26

20
Fig. 27
(5) Insert both loose ends of the line through the cord
guide (22) when placing the reel in the case. (Fig.
29)
NOTE
When placing a reel in the case, try to line up the
stopper holes (21) with the cord guide (22) for
easier line release later.
(6) Place the cover over the case so that the cap
locking tabs on the case meet the long holes on
the cover. Then push the case securely until it
clicks into place. (Fig. 30)
English
21
Fig. 28
21
22
Fig. 29
Fig. 30
13