Troubleshooting; Scrapping - Clarke BSW 28 Manuel D'utilisation

ENGLISH

TROUBLESHOOTING

Trouble
The machine does not start when turning the
main switch to "I" or to "II".
The side broom does not operate.
The machine operates only when stationary,
otherwise it turns off and the red warning
light flashes.
The battery autonomy is low.
The batteries do not charge: the red warning
light (4) does not turn on when the plug is
inserted in the electrical mains socket.
For further information, refer to the Service Manual, available at any Clarke Service Center.

SCRAPPING

Have the machine scrapped by a qualified scrapper.
Before scrapping the machine, remove and separate the following materials, which must be disposed of properly according to
the Law in force:
– Battery
– Brooms
– Plastic hoses and components
– Electrical and electronic components (*)
(*) Refer to the nearest Clarke Center especially when scrapping electrical and electronic components.
16
Possible cause
There is an open in a breaker (21).
The battery charger cable is connected to
the electrical mains.
The batteries are discharged.
There is an open in a breaker (20).
The batteries are discharged.
The batteries are dead.
There is no power supply at the electrical
mains socket.
Remedy
Reset the breaker by pressing the relevant
button.
Disconnect it and place it in the housing.
Charge the batteries.
Reset the breaker by pressing the relevant
button.
Charge the batteries. If the trouble persists,
have the batteries replaced at Clarke
Service Center.
Have the batteries replaced at Clarke
Service Center.
Check the electrical mains socket by trying
to connect another domestic appliance.
Operator's Manual - BSW 28