Rupes SSPF Notice D'emploi Et D'entretien page 10

SSPF - SO31TE VELCROED DRILLED RUBBER PLATE VERSION
- Rip off the used paper;
- press the new velcro backed paper in position, ensuring that the
holes in the paper coincide with the suction holes in the plate.
USABLE ABRASIVE PAPER
- Sheets of abrasive paper for orbital sanders;
- punched velcroed sheets of abrasive paper for suitable models.
MAINTENANCE
All maintenance operations are carried out with the power supply
disconnected.
- Periodically check the tightness of the screws in the corners of the
upper part of the plate (6);
- at the end of each work session, or when required, clean the motor
ventilation slot protective filter and remove any dust from the body
of the tool using a jet of compressed air, paying particular attention
to the motor ventilation slots;
- for the SSCA version, empty the dust collection bags.
No other maintenance operations must be undertaken by the user.
Maintenance and cleaning of the inner parts, like brushes, ball
bearings, gears etc. or others, must be carried out only by an
authorized customer-service workshop.
ATTENTION!
In order to have a good working
of the tool, we recommend to lock,
after some hours of work,
the four screws that tighten
the rubber plate (see drawing).
ELECTRIC SAFETY - LOW TENSION
The tests have been carried out in accordance with the standard:
EN 60745-1 safety of hand-held electric motor operated tools
EN 60745-2-4 particular requirements for sanders.
10
RADIO SUPPRESSION
The tools are suppressed in accordance for the prevention and
elimination of radio disturbances measured in accordance with
standard: EN55014-1+EN55014-2; EN61000-3-2+EN61000-3-3.
NOISE
The noise level produced is:
77,5 dB for SO31TE; 84,5 dB for SSPF; SSCA
measured according to regulation EN ISO 3744 + UNI EN ISO 11202.
Warning: wear suitable hearing protections! (see warnings).
MEAN ACCELERATION VALUE
The mean quadratic acceleration value is less than 2,5 m/sec
measured in accordance with standard UNI EN 28662 + UNI EN ISO
5349.
GUARANTEE
All tools manufactured by RUPES Spa are guaranteed for 12 months
from the date of purchase against fabrication and material defects.
All tools must be used only with RUPES original accessories and spa-
re parts: we refuse all responsibility for damages or accidents cau-
sed by non-observance of this rule which will also cause the termina-
tion of the guarantee.
The guarantee will no longer be valid if the instructions contained in
SSPF - SSCA
this booklet are not followed, if the tool is used for purposes other
than that for which it is intended, if it is dismantled, interfered with in
any way or damaged due to neglect.
The guarantee will be made valid by filling-in the form on the
inside back cover of this instruction booklet.
If the tool is found to be defective or malfunctions, it should be retur-
ned carriage free in one piece in its original packing together with the
guarantee certificate to the manufacturer or to one of the Assistance
Centres listed in the appendix to this booklet.
The guarantee does not automatically imply replacement of the tool.
RUPES Spa reserves the right to make any technical or design modi-
fication to its products without prior notice.
The manufacturer is not liable for any print errors. This document
voids and replaces previous ones.
2