Care And Maintenance - Hotpoint Ariston KIC 644 C Mode D'emploi

Care and maintenance

Switching the appliance off
Disconnect your appliance from the electricity supply
before carrying out any work on it.
Cleaning the appliance
Do not use abrasive or corrosive detergents (for
!
example, products in spray cans for cleaning barbecues
and ovens), stain removers, anti-rust products, powder
detergents or sponges with abrasive surfaces: these may
scratch the surface beyond repair.
Never use steam cleaners or pressure cleaners on the
!
appliance.
• It is usually sufficient simply to wash the hob using a
damp sponge and dry it with absorbent kitchen towel.
• If the hob is particularly dirty, rub it with a special glass
ceramic cleaning product, then rinse well and dry
thoroughly
• To remove more stubborn dirt, use a suitable scraper.
Remove spills as soon as possible, without waiting for
the appliance to cool, to avoid residues forming crusty
deposits. You can achieve excellent results by using a
rust-proof steel wire sponge - specifically designed for
glass ceramic surfaces - soaked in soapy water.
• If any plastic or sugary substances are accidentally
melted on the hob, remove them immediately with the
scraper, while the surface is still hot.
Technical description of the models
The induction system is the quickest existing way of cooking. Unlike traditional hotplates where the cooking zone
heats up, with the induction system heat is generated directly inside pans which have ferromagnetic bases.
Hobs
KIC633C
Cooking zone Power (W)
Back Left I 1400 - B 2000* - 600 if Front Left*
Back Right I 2200 - B 3000* - 1600 if Front Right*
Front Left I 2200 - B 3000* - 1600 if Back Left*
3000 - B 4000
Front Right
Total power 7600
Key:
I = single induction cooking zone
B = booster: the power level of the cooking zone may be boosted to 3000 W
* = the maximum power level is limited while the booster is activated for the relevant rear cooking zone (see Start-up
and use).
KIC644C
Power (W)
I 1400 - B 2000* - 600 if Front Left*
I 2200 - B 3000* - 1600 if Back Left*
I 1400 - B 2000* - 600 if Back Right*
7200
• Once it is clean, the hob may be treated with a special
protective maintenance product: the invisible film left by this
product protects the surface from drips during cooking. This
maintenance task should be carried out while the appliance
is warm (not hot) or cold.
• Always remember to rinse the appliance well with clean
water and dry it thoroughly: residues can become encrusted
during subsequent cooking processes.
Stainless steel frame (only in models with outer frame)
Stainless steel can be marked by hard water which has been
left on the surface for a long time, or by cleaning products
containing phosphorus.
After cleaning, it is advisable to rinse the surface well and dry
it thoroughly. If water is spilt on the surface, dry it quickly and
thoroughly.
! Some hobs have an aluminium frame which is similar to
stainless steel. Do not use any cleaning or degreasing products
which are not suitable for use with aluminium.
Disassembling the hob
If it is necessary to disassemble the hob:
1. Loosen the screws fixing the alignment springs on each side.
2. Loosen the screws holding the fixing hooks in each corner.
3. Take the hob out of its installation cavity.
Do not attempt to repair the appliance yourself. If the
!
appliance breaks down, contact a Service Centre.
GB
15