Fcc Compliancy - Philips SRU9600 Mode D'emploi

Limited one year warranty
Warranty coverage begins the day you buy your product. For one year
thereafter, a defective or inoperative product can be returned to the place
of purchase and it will be replaced with a new or comparable product at no
charge to you.You must have proof of purchase to exchange the product.
This warranty does not extend to the product if damaged or rendered
defective because of misuse, accident, unauthorized repair, modification or
other cause not within the control of Philips Consumer Electronics.
Replacement as provided under this warranty is the exclusive remedy for
the consumer. Philips shall not be liable for any incidental or consequential
damages for breach of any express or implied warranty on this product.
Except to the extent prohibited by applicable law, any implied warranty of
merchantability or fitness for a particular purpose on this product is limited
in duration to the duration of this warranty.
This warranty gives you specific legal rights.You may have other rights which
vary from state/province to state/province.

FCC Compliancy

This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions:
- This device should not cause harmful interference
- This device must accept any interference received, including interference
that may cause undesired operation
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC rule and ICES 003 in
Canada.
These limits are designed to provide reasonable protection against harmful
interference in residential installations.This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation. If the equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by using one or more of the following measures:
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver
- Connect the equipment into to an outlet on a different circuit from the
receiver
- Consult the dealer or an experienced radio/TV technician for help.
Caution: User changes or modifications not expressly approved by the
party responsible for compliance may void the user's authority to operate
the equipment.
23