Standard Accessories; Applications - HIKOKI CN 16SA Mode D'emploi

h) Keep handles and grasping surfaces dry, clean
and free from oil and grease.
Slippery handles and grasping surfaces do not
allow for safe handling and control of the tool in
unexpected situations.
5) Service
a) Have your power tool serviced by a qualifi ed
repair person using only identical replacement
parts.
This will ensure that the safety of the power tool is
maintained.
PRECAUTION
Keep children and infi rm persons away.
When not in use, tools should be stored out of reach of
children and infi rm persons.
PRECAUTIONS ON USING NIBBLER
1. Ensure that the power source to be utilized conforms
to the power requirements specifi ed on the product
nameplate.
2. Ensure that the power switch is in the OFF position.
If the plug is connected to a receptacle while the power
switch is in the ON position, the power tool will start
operating immediately, which could cause a serious
accident.
3. When the work area is removed from the power source,
use an extension cord of suffi cient thickness and rated
capacity. The extension cord should be kept as short as
practicable.
4. Beware of sharp panel edges.
The edge of the plate just cut by the nibbler is very sharp.
Take care in not getting hurt by the sharp edge.
5. If shavings get into the machine, it will produce problems
or accidents. Do not place the machine on the shavings.
6. Shavings are hot immediately after they are cut. Never
touch them with bare hands.
7. Preserve the power cord. Be sure that the power cord is
not abraded or cut by the sharp edge of the cut panel.
8. Die Inspection
Inspect for looseness of the M8 hexagon socket set
screw used for mounting the die holder, the M3 machine
screws used for mounting the die (see Fig. 1) and
the M5 hexagon socket set screws used for mounting
the punch (see Fig. 1). Caution should be exercised
because, if any of these screws are loose, not only does
cutting performance deteriorate but the machine can
also be damaged.
9. Lubrication
Before use, carefully lubricate the sliding surfaces
around the die and punch (see Fig. 1) with a suitable
amount of machine oil or spindle oil.
10. Cutting
○ Never try to cut materials that are too large for the
capacity of the machine since this may cause damage.
○ Applying cutting oil (spindle oil, machine oil, and so on)
along the shearing line may decrease wear of the punch
and die.
Use care to prevent cutting oil adhering to the housing
since the surface may be damaged.
○ The cutting directions of Punch shape (I) (see Fig. 8) are
in the 3 directions of A, B and C and these directions can
be changed, but punch shape (II) can be cut in direction
B only. (See Fig. 8)
SYMBOLS
WARNING
The following show symbols used for the machine.
Be sure that you understand their meaning before
use.
CN16SA : Nibbler
To reduce the risk of injury, user must read
instruction manual.
Always wear eye protection.
Only for EU countries
Do not dispose of electric tools together with
household waste material!
In observance of European Directive 2012/19/
EU on waste electrical and electronic equipment
and its implementation in accordance with
national law, electric tools that have reached
the end of their life must be collected separately
and returned to an environmentally compatible
recycling facility.
V Rated voltage
Alternating current
min Revolution or reciprocations per minute
-1
Switching ON
Switching OFF
Warning
Disconnect mains plug from electrical outlet
Class II tool

STANDARD ACCESSORIES

In addition to the main unit (1 unit), the package
contains the accessories listed in the below.
○ Hex. bar wrench ............................................................1
Standard accessories are subject to change without notice.

APPLICATIONS

Cutting and pocket cutting mild steel, stainless steel, copper
and aluminium plates corrugated plates and trapezoidal
plates.
3
English