Waterpik WP-650 Mode D'emploi page 7

into sink. Turn power on.
Slide water switch ON until
water flows from the tip with
substantial force. Turn
power OFF.
Adjust Pressure and Mode Selection
For first time users, adjust
pressure control to lowest
position. Gradually increase
pressure to your liking. Press
the mode button once and
one LED will display current
mode. Press mode button
again to change modes.
Floss Mode is suggested
for first time use.
Using Your Waterpik
Always place tip in
mouth before turning
water ON. With water
switch on handle in OFF
position, turn power on. Lean over sink and close
lips enough to prevent splashing, while still allowing
water to flow from mouth into the sink. Turn water
switch ON. When finished, turn water switch
and power OFF.
Water
ON
Water on
Low
Floss
Massage
Floss
Massage
Floss
Waterflosser
®
Power
Floss
Massage
ON
Floss
Massage
During use, you can stop water
flow by sliding water switch
on handle to the OFF position.
NOTE: Motor will continue
to run.
Technique Tips for Best Results
Aim the water
stream just above
the gumline at a
90 degree angle.
Starting with the back teeth, follow the gumline and
pause briefly between teeth. Continue until all areas
around and between teeth have been cleaned.
One-Minute Timer/30-second
Pacer (Floss Mode Only)
The Water Flosser will create a short
pause at 30-seconds, to remind
you to move to the other arch
of your mouth and another
short pause at 1-minute
to signal you have reached
the recommended cleaning
time. The unit will continue to
run without pauses until the unit is
turned off. Depending on the pressure setting, some
water will remain in the reservoir after 1-minute.
Timer may be deactivated if desired. Steps to
deactivate:
1. While unit is off, press the mode button once to
wake the unit up. One of the LEDs should light up.
2. Press and hold the mode button for
approximately 3-seconds until the Massage
Mode light blinks. The timer is now deactivated.
7
Water
OFF
Upper Arch
30 sec.
30 sec.
Lower Arch