Using the LCD-monitor
Setting the monitor (fig. d, page 8)
8.4
To set the monitor to suit your requirements, proceed as follows:
➤ Press the "MENU" button (3) to call up the required parameter.
✓ The parameters to be set appear in the following order:
Page 1:
– Brightness: 0 – 100
– Contrast: 0 – 100
– Colour: 0 – 100
– Language: "English" or "German"
Page 2:
– Reset ("Default"): Default setting for all parameters
– Camera 1: "Normal" or "Mirrored"
– Camera 2: "Normal" or "Mirrored"
➤ Press the "–" button (4) or "+" button (5) to set the parameter of your choice.
➤ Press the "–" button (4) to reduce the value of the selected parameter.
➤ Press the "+" button (5) to increase the value of the selected parameter.
Setting the video source (fig. d, page 8)
8.5
I
NOTE
If you have connected the green cable to the reversing light and voltage is present,
reversing camera V1 is activated automatically.
➤ If you wish to switch to a different video source (from camera 1 to camera 2), press the
"C1/C2" button (2).
✓ The monitor switches from camera 1 to camera 2 or vice-versa.
22
M7LS
EN