Bresser 7002571 Mode D'emploi page 12

6. Repeat steps 1 to 4 as before.
7. Place the assembly base with its bottom site first on the tube. Push the tube bracket against the
tube from the opposite site.
8. Slide 4 screws through the bore holes of the assemby base and through the bore holes of the tube
bracket on the other site.
9. Put on the 4 nuts and tighten the screw connection by hand.
12 Signal transmission
The base station will automatically connect to the multi outdoor sensor and (if available) to other wire-
less sensors. Press the SENSOR SYNC button to search for sensors directly. After successful con-
nection, the symbol for the outdoor area (OUT) and/or the channel are displayed.
Connection status display
Connection status
Good signal
Searching for a sensor
No signal for 48 hours
Sensor low battery status, good signal
13 Time synchronization with the PC
Time and date are automatically synchronized for this unit when it is connected to a computer* using
the supplied USB cable. Proceed as follows:
1. Plug the microUSB plug of the USB cable into the USB socket on the device.
2. Plug the USB A plug of the USB cable into a free USB port on the computer.
3. Switch on the computer and wait about 5 seconds.
4. Start the 'WEATHER TOOL' software. This synchronizes the time.
5. Press the TIME SYNC button for about 8 seconds to deactivate or activate time synchronization.
6. Press the TIME SYNC button once to restart time synchronization.
NOTICE! The time synchronization is carried out via the software on the connected computer
with the time set there. Make sure that it is set correctly and that the software remains open un-
til the time has been synchronized. After successful synchronization, this is indicated by the syn-
chronization symbol in the display.
*Computer with Windows 7 or higher required.
NOTICE! If the device is connected to the computer via USB, it is supplied with power as soon as
the computer is switched on.
14 EC Declaration of Conformity
Hereby, Bresser GmbH declares that the equipment type with item number 7002571 : is in compli-
ance with Directive: 2014/30/EU. The full text of the EU declaration of conformity is available at the
following internet address: www.bresser.de/download/7002571/CE/7002571_CE.pdf
15 Disposal
Dispose of the packaging materials properly, according to their type, such as paper or card-
board. Contact your local waste-disposal service or environmental authority for information
on the proper disposal.
12 / 56
Screen display
Reception icon
Reception symbol flashes
'Er' (Error) is shown
Battery symbol is shown