Emergency Information; Putting Into Operation - Abicor Binzel PP Série Mode D'emploi

4 Putting into operation

3.3 Emergency information

4 Putting into operation
EN - 6
WARNING
Describes a potentially dangerous situation. If not avoided, this may result in
serious injuries.
CAUTION
Describes a potentially harmful situation. If not avoided, this may result in
slight or minor injuries.
NOTE
Describes the risk of impairing work results or potential material damage to
the equipment.
In case of emergency, immediately interrupt the following supplies:
• Electricity, compressed air
Further measures can be found in the "Power supply" operating instructions or
in the documentation of further peripheral devices.
DANGER
Risk of injury due to unexpected start-up
The following instructions must be adhered to for the entire duration of
maintenance, servicing, mounting, dismounting and repair work:
• Switch off the power source.
• Close the gas supply.
• Close off the compressed air supply.
• Disconnect all electrical connections.
• Switch off the entire welding system.
NOTE
• Please take note of the following instructions:
 2 Safety on page EN-3
• The system may only be installed and put into operation by authorized
personnel (in Germany see TRBS 1203).
Equip the torch neck according to one of the following figures:
PP