Electrical Connection - DeWalt DW735 Guide D'utilisation

• Avoid prolonged contact with dust from power sanding,
sawing, grinding, drilling, and other construction activities.
Wear protective clothing and wash exposed areas with
soap and water. Allowing dust to get into your mouth, eyes, or
lay on the skin may promote absorption of harmful chemicals.
WARNING: A dust mask or respirator should be worn by all
persons entering the work area. The filter should be replaced daily or
whenever the wearer has difficulty breathing. See your local hardware
store for the proper NIOSH/OSHA approved dust mask.
• The label on your tool may include the following symbols. The
symbols and their definitions are as follows:
V .....................volts
Hz ...................hertz
min .................minutes
or DC .....direct current
...................Class I Construction
.......................(grounded)
...................Class II Construction
(double insulated)
.../min ............per minute
BPM ...............beats per minute
IPM .................impacts per minute
RPM ...............revolutions per
minute
sfpm ...............surface feet
.......................per minute
SPM ...............strokes per minute
Specifi cations

Electrical Connection

A .......................amperes
Be sure your power supply agrees with the nameplate marking. Volts,
W ......................watts
50/60 Hz or "AC only" means your planer must be operated only with
alternating current and never with direct current. Voltage decrease of
or AC ...........alternating
more than 10% will cause loss of power and overheating. All D
current
tools are factory tested, if this tool does not operate, check the power
or AC/DC ....alternating
supply.
..........................or direct
Transporting the Planer (Fig. 1)
current
n o ......................no load
recommended that two people carry this
speed
machine or serious injury could result.
When moving your planer, carry it either by the
n ........................rated
side carrying handles (A) or by the handles at
..........................speed
the base of the planer (B).
......................earthing
Bench Mounting (Fig. 1)
terminal
To facilitate bench mounting, two different
......................safety alert
sized holes (D) are provided on the four
symbol
corners of your planer. If mounting the planer
with bolts, use the larger holes. If mounting
the planer with nails or screws, use the smaller
holes. It is not necessary to use both sets of
holes.
4
Input .................... 120 V AC , 15 Amp
No load speed ..... 10,000 RPM
Feed speed ..........14 ft. (4.3 m) per minute
.............................or 26 ft. (7,9 m) per minute
Planing height ...... Maximum 6" (152 mm), Minimum 1/8" (3 mm)
Planing width ....... Maximum 13" (325 mm)
Planing depth ...... Maximum 1/8" (3 mm)
(for boards 6" (152 mm) wide or less)
WARNING: For your own safety, it is
WALT
E
FIG. 1
A
B
D