DeWalt DW735 Guide D'utilisation page 14

Circuit Breaker Reset Button (Fig. 23)
Your planer is equipped with an 18 amp
circuit breaker. If your planer becomes
overloaded and stops operating, turn off the
planer, let the unit sit for 2 minutes and
press the reset button (X) before you resume
working.
WARNING: To prevent the planer from
starting unexpectedly if power is interrupted by
a circuit breaker trip, make sure the switch is in
the OFF position before restoring power.
NOTE: Circuit breaker overload is often the result of dull knives.
Change your knives on a regular basis to avoid tripping your
breaker. Check your knives before re-setting the circuit breaker and
continuing to plane.
See the Troubleshooting Guide for additional information on circuit
breaker trips.
Replacing the Drive Belt
Drive belts are available at extra cost at D
centers. Replacement of the drive belt should be performed by
qualified service personnel.
Chip Ejection Fan (Fig. 24)
The chip ejection fan on your planer should
be cleaned or cleared of debris periodically.
WARNING: Turn off and unplug the planer
prior to accessing the chip ejection fan.
TO ACCESS THE FAN
1. Remove the top cover of the planer with the T-wrench.
2. Remove the dust shroud (Fig. 14–16) and place it aside.
3. Remove the screws and clips around the fan housing.
4. Remove the fan housing and place it aside as shown. The fan will
FIG. 23
See the Troubleshooting Guide for additional information.
X
assemble the shroud and top cover correctly before using your planer
again.
Accessories
D
E
accessories with this tool could be hazardous. To reduce the risk of
injury, only D
this product.
Recommended accessories for use with your tool are available at
extra cost from your distributor or local service center.
Four accessories are available for the DW735 Thickness Planer.
• DW7350 Mobile Stand
• DW7351 Folding Tables
• DW7352 13" (325 mm) Knives
WALT authorized service
E
• DW7353 Chip Ejection Accessory
If you need any assistance in locating these accessories, please
contact D
FIG. 24
Baltimore, MD 21286 or call 1-800-4-D
www.dewalt.com
DW7351 Accessory Folding Tables
(Fig. 25)
before attaching the tables. Failure to heed these warnings may
result in personal injury and serious damage to the planer and the
accessory. When servicing this tool, use only identical replace ment
parts. Have damaged cords replaced by an authorized service
center.
12
now be exposed for cleaning.
WARNING: Be sure to properly attach the fan housing and
WARNING: Since accessories, other than those offered by
WALT, have not been tested with this product, use of such
WALT, recommended accessories should be used with
E
WALT Industrial Tool Co., 701 East Joppa Road,
E
WARNING: For your own safety, read the tool instruction manual
WALT (1-800-433-9258) or
E