ShelterLogic Peak Shelter Manuel D'assemblage page 6

6. INSTALL TOP CROSS RAIL
A. Connect the first cross rail (#10133) to the front end rib and secure it with bolt #10115. Fig. 6A. HAND-
TIGHTEN this bolt.
B. Connect the next cross rail (#10134) to the first cross rail. Lay them over the top of the middle rib and
connect using bolt #802630. Fig. 6B.
C. Connect top cross rail to rear end rib with bolt #10115. Fig. 6A. HAND-TIGHTEN this bolt.
Top Cross Rail at End Rib
10115
10121
01010
Fig.6A
7. SQUARING UP THE FRAME
A. Be sure that frame in its final location, which needs
to be as flat and level as possible.
B. Measure across opposite corners.
These distances must be equal to within 1 inch.
C. Check that the front and rear of the frame
measures 11 feet in width.
8. INSTALL AUGER ANCHORS
A. Anchors must be placed inside shelter at the corner
legs. Insert a ¾-inch pipe or steel rod through the eyelet
of the auger and turn the anchor clockwise until the
eyelet is sticking out of the ground 1 to 2 inches allowing
room to be anchored to the legs.
B. Thread cable provided through the eyelet of the Anchor
as indicated in figure 9. Secure the cable with the
clamps provided.
If the ground is too hard, dig a hole with a shovel or post
hole tool. Optional: Fill with cement.
15" Augers are for temporary use only. For best
results, ShelterLogic
Hook ™ Drive Anchors. Use one at each leg for a
stronger, more secure installation.
recommends the Easy
®
11 ft.
Fig.8
Middle Rib
Page 6
Top Cross Rail OvER Middle Rib
802630
Fig.6
01010
Fig.7
11 ft.
End Rib
05_10JT33_A4