Judo SOFTwell Instructions De Montage page 11

Fig. 2: Module insertion for SOFTWELL
P / S and i-soft 5 TGA
1 Connectivity module
2 LAN cable
3 Sticker MAC address + QR code
3. Connect connectivity module and electronic control of appliance
- Only for Softwell K: remove the cover and pull the control unit out of the housing.
- Plug both connectors of the cable on the connector pins A1 and A2 of the electronic
control unit (see Figure 4).
- Insert the cable into the 2- and 3-pin ports of the of the connectivity module (see
Figure 5).
Attention: Risk of damage to the device! Do not confuse the connectors!
1702929 • 2019/08
Installation in water softener SOFTwell
JUDO Connectivity-Modul
Fig. 3: SOFTwell K: Fastening with
hook-and-loop adhesive pads /
mounting position
1 Hook-and-loop adhesive pads
2 LAN cable
11