Additionally Needed For Installation; Ports; Installation In Water Softener Softwell - Judo SOFTwell Instructions De Montage

3

Additionally needed for installation

• LAN-cable or powerline adapter to connect to the home network
4

Ports

Fig. 1: Ports
1 LAN port
2 Port for connection cable to the appliance control
3 USB port
(only for JUDO Customer Service)
5

Installation in water softener SOFTwell

1. Unplug the power supply unit!
2. Attach the connectivity module to the device
For SOFTWELL P , SOFTWELL S and i-soft 5 TGA (see Figure 2):
- Remove the cover of the Softwell or i-soft water softening system.
- Insert the connectivity module in the recess on the left side of the casing so that the
LAN port points downwards.
- Route the LAN cable to the rear through the opening in the connection flange and
secure with cable ties.
For SOFTWELL K (see Figure 3):
- Stick the two supplied hook-and-loop adhesive pads on the connectivity module as
shown.
- Pull off the protective film of the adhesive pads and stick the module in the recess of
the softener rear-side.
- Before attaching the pads, ensure that the surfaces are clean and free from grease!
- Pull off the protective film of the adhesive pads and stick the module in the recess of
the softener rear-side.
10
Additionally needed for installation
JUDO Connectivity-Modul 1702929 • 2019/08