EN
NOTICE – Risk of Damage to Material and Property
■
The device should only be connected to a properly installed plug socket. The plug sock-
et must also be readily accessible after connection so that the connection to the mains
can quickly be isolated. The mains voltage must match the rating plate of the device.
■
The device should only be used if it has been correctly assembled!
■
Do not operate the device without food. This might result in the device overheating or
damage to the motor.
■
Unwind the connecting cable fully before connecting up the device.
■
Remove the mains plug if a fault occurs during operation. Otherwise always switch off
the device first before the mains plug is pulled out of the plug socket.
■
Always pull the mains plug and never the connecting cable when disconnecting the
device from the mains power. Do not pull or carry the device by the connecting cable.
■
Always check the device for damage before putting it into operation. The device should
only be used when it is undamaged, and in working order! Do not use the device if it has
malfunctioned, fallen or been dropped in water. Have it checked in a specialist workshop
before using it again.
■
Always place the device on a dry, even, firm and heat-resistant surface. Never place the
device on a soft surface. The ventilation slots on the bottom of the device must not be
covered. Otherwise it could overheat and be damaged.
■
Do not place the device on or next to heat sources such as hobs or ovens. Keep naked
flames, e.g. burning candles, away from the device and the connection.
■
Do not expose the device to extreme temperatures, persistent moisture, direct sunlight
or impacts.
■
Never place objects on the device or the connection.
■
Use only original accessories from the manufacturer in order to guarantee that there is
no interference that may prevent the device from working and to avoid possible damage.
Items Supplied
•
Main device (1 x)
•
Mixing bowl (1 x)
•
Stirring attachment (1 x)
•
Dough hook (1 x)
•
Whisk (1 x)
•
Operating instructions (1 x)
Check the items supplied for completeness and the components for transport damage.
If you find any damage, do not use the device but contact our customer service depart-
ment.
Remove any possible films, stickers or transport protection from the device. Never re-
move the rating plate and any possible warnings!
16