Automatic Mode; Dehumidifier Mode; Timer Function - Domo DO191A Mode D'emploi

DO-191A
Standby
If you press on the standby button a second time the appliance will produce a
single acoustic signal then switch off.
MODES

Automatic Mode

If the function has been selected, the sensor will automatically adjust to the
correct mode: or .
If room temperature is higher or equal to 24°C the appliance will automatically select
the cooling function .
If the temperature is lower than 24°C the appliance will automatically switch to adjust
to the correct ventilation speed .

Dehumidifier Mode

The top ventilator operates at low speed and the rate cannot be adjusted.
The compressor and the bottom ventilator will stop after 8 minutes and switch on
again after 6 minutes.
The appliance runs in continuous dehumidifier mode and adjusting the temperature
will have no effect.
Cooling Mode
If the room temperature is higher than the selected temperature the compressor will
switch on.
If the room temperature is lower that the selected temperature the compressor will
switch off and the top ventilator will operate according to the selected temperature.
Ventilator Mode
The top ventilator operates at the selected speed and the compressor and bottom
ventilator are switched off.
Adjusting the temperature in this setting will have no effect.

Timer Function

Press on the 'Timer' button in order to select the function 'automatic off' if the
appliance is running. Press on the 'Time' button in order to select the function
'automatic on' if the appliance is running. The timing can be adjusted from 1 to 24
hours. Press on the ▲ button or the ▼ button in order to increase or decrease the time
duration by 1 hour.
Sleep Settings
The sleep setting function is only applicable when the appliance is set to the cooling
mode (high speed ventilation) .
29