Signature SRT1002A++X Instructions D'utilisation page 33

4. Lift the door and place it on a padded surface to prevent scratching
DOOR REVERSE
it.
5. Take off the leg(8). Remove the three screws(9) that hold the lower
hinge(10) and take away the lower hinge(10).
6. Unscrew the screw(12) and remove the leg(13). Then transfer it to right
side.
7. Remove the bolt-pin(11) and reverse the direction of lower hinge(10).
Install the lower hinge (10) into left side with three screws (9).
8. Insert the bolt-pin(11) to the lower hinge(10).
9. Remove the hinge pin (14)(15)(16) that is in the bottom of door. At the
other side of door, insert the replacement hinge pin that is supplied
with the appliance.
10. Set the door to its place and make sure the door seat at the lower
hinge (10).
11. Fix the upper hinge (5) with the two screws (4).
12. Install the top with four screws(2)(3) and cover screw (2) with cover
(1).
figure 1
Figure 1: Represents position of components prior to door reversal
Figure 2: Represents position of components after door reversal
Installing the handles
This refrigerator has been built with external handles, which are in poly
bag. Please follow instruction below to install them:
1. Remove two screws(17) by a cross screwdriver.
2. Take out the handles(18) and fix it with the two screws(17).
-31-
figure 2