Troubleshooting - Triton TRA001 Instructions D'utilisation Et Consignes De Sécurité

TROUBLESHOOTING

SYMPTOM
Router will not operate
Router runs slowly
Makes an unusual sound
Excessive vibration
Heavy sparking occurs inside motor
housing
Micro adjuster "clicks"
Plunge lock lever not locking
Shutter on power switch not releasing
Can't plunge to collet lock position
GB
Troubleshooting
10
330165_Z1MANPRO1(with Japanese).indd 10
POSSIBLE CAUSE
No supply of power
Brushes worn or sticking
Switch is faulty
Motor components faulty or short
circuited
Blunt or damaged cutter
Variable speed set low
Motor is overloaded
Mechanical obstruction
Armature has shorted sections
Bent cutter shank
Brushes not moving freely
Armature short circuited or open circuited
Commutator dirty
Plunge lock engaged
Plunge selector button is engaged
Reached end of adjustment range.
Plunge lock lever not correctly positioned
Router is plunged to full depth - in collet
lock position
Power switch "On"
REMEDY
Check that power is available at source
Disconnect power, open brush caps and ensure
brushes move freely in the holders. Check whether
the brushes require replacing - see Page 9
Go to www.tritontools.com for your nearest Triton
Approved Service Agent
Go to www.tritontools.com for your nearest
Triton Approved Service Agent
Re-sharpen or replace cutter
Increase variable speed setting
Reduce pushing force on router
Go to www.tritontools.com for your nearest Triton
Approved Service Agent
Go to www.tritontools.com for your nearest Triton
Approved Service Agent
Replace cutter
Disconnect power, remove brushes, clean or
replace
Go to www.tritontools.com for your nearest
Triton Approved Service Agent
Go to www.tritontools.com for your nearest Triton
Approved Service Agent
Release plunge lock lever
Disengage the plunge selector button. Refer to
'Handle Winder Plunge'
Reset the router
Reposition plunge lock lever as described in 'Free
Plunge'
Reduce plunge depth
Switch power 'Off'
21/07/2014 09:49