Dyson AM10 Guide D'utilisation page 23

Some cleaning chemicals are harmful to the Dyson
AM10 humidifer and should not be used. Use of these
will invalidate your warranty. Do not use: Alcohol
and strong acid mixes, solvent (acetone) and oil
based products, alkali bleach mixes, air fresheners,
aroma oils, scented oils, hot water, brushes, abrasive
materials, etc. Please do not put in a dishwasher
or close to a fire.
2
Using a damp cloth, wipe over both sections with the
citric acid solution. Do not put in a dishwasher or rinse
under the tap.
5
To remove the seal, pinch the securing tabs together
and pull out. Clean thoroughly by immersing in the
recommended citric acid solution for 15 minutes. Rinse
and wipe over all surfaces. Repeat if necessary. To refit,
push back in so the tabs click and the fit is secure.
citric acid solution until the UV-C emitter and piezo are
submerged. Leave for 15 minutes. Drain, rinse and
wipe over all surfaces. Repeat if necessary.
Piezo
15 mins
UV-C
emitter
3
To attach the loop amplifier surround, lie flat and
align the surround to the main amplifier. Push firmly
until it clicks into place as shown.
6
Pour in the recommended acid citric solution. Replace
the cap and shake tank for 30 seconds. Then leave
to stand. After 15 minutes, empty the tank. Rinse and
wipe over all surfaces. Repeat if necessary.
8
Re-assemble. Wipe the exterior with a lint-free
microfibre cloth. Switch 'ON': the water treatment
procedure starts. After 3 minutes the Dyson AM10
humidifer will start to humidify.
15 mins
23