Dyson AM10 Guide D'utilisation page 22

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Once a month
(and before/after storage)
Repeat this process more frequently if you live in
a hard water area or limescale deposits are present.
Turn the Dyson AM10 humidifer
into standby mode/'OFF'.
Unplug from the mains electricity supply.
22
1
Unclip the loop amplifier
surround: pull from both sides of
the lower tab, gently but firmly.
4
Empty the water tank. To release the water chimney, twist
the dial a quarter of a turn. Lift out. Clean thoroughly by
immersing in the citric acid solution for 15 minutes. Rinse
and wipe over all surfaces. Repeat if necessary. Refit in
reverse order, twisting the dial a quarter of a turn to secure.
7
Empty the trough of any water, small spillages may occur.
While not dangerous, care should be taken to avoid
water entering the inlets. Clean thoroughly, using the
recommended citric acid solution. Do not rinse under the tap
or put in a dishwasher. Fill the trough with the recommended
15 mins

Publicité

Table des Matières
loading

Table des Matières